G&G Drawers - Two down and four to go

I completed the center drawers (one for each desk) this past weekend.  See below:

Note the traditional Greene and Greene exposed box joints on the drawer fronts.  The pins stand proud on the front of the drawers by about 1/8 of an inch. The drawer backs are installed with sliding dovetails.  The Incra LS router table jig made the construction of the drawers fast and easy.  I left the sides of the drawers long in the back so that they can be pulled out to expose the entire drawer contents without falling.

I began cutting the parts for the four side drawers also, and I hope to complete them this week.